Glass Moulds
Made from laboratory grade heatproof glass. These moulds produce flawless candles every time. Available in a wide range of diameters and heights.
- To help the candles release from the mould, rinse in soapy water and shake off the drops or spray with silicone.
- Dip the correct size wick (wick should be slightly less in diameter than the diameter of the mould) into molten wax until all air bubbles have come out. Warm the mould gently by a fan heater.
- Arrange the mould so that it is held vertically with the wick supported a few centimetres above the mould. Seal the wick where it exits the mould with plasticine or wax glue.
- Pour the wax at about 75ºC. The hollow formed in the base as the wax cools can be filled with fresh wax.
- When the candle is quite cool, remove it from the mould. A sharp tap with the hand may help it or a spell in the freezer may encourage really stubborn ones.
